Fronius TransPocket 5000 CEL - Page 79

11
EN
Service-Code: -OFF-
Cause: Poor contact with the workpiece
Remedy: Create a solid, firm connec-tion to the workpiece
Service-Code: -E62-
Cause: Overtemperature on the TP 08 r.-c. unit
Remedy: Allow the TP 08 to cool down
As long as a service code is displayed on the power source or any other system add-
on, the TP 08 remote-control unit is out of action.
(ZN) Parameter selection button ... For selecting the parameters
- Welding current (ZO)
- Arc-force dynamic (ZP)
(ZQ) (+) button ... Increases the value for the selected parameter
(ZR) (-) button ... Decreases the value for the selected parameter
NOTE! Irrespective of the service codes given in the “Troubleshooting” sec-
tion, the following service codes may be displayed on the TP 08 remote-control
unit:
TP 08 remote-
control unit
(continued)