Fronius VR 5000 - MIG;MAG Setup and Operating Points; Rod Electrode Setup

122
Gas pre-fl ow time Gas post-fl ow time Threading speed Burn-back effect Ignition current Length of wire before the safety cut-out trips Restoring factory setup 2nd menu level
Cooling unit control Cooling unit watchdog Country setting Welding circuit resistance Welding circuit inductivity Real Energy Input
MIG/MAG - setup Manual
Display service parameters
Operating points
briefl y press
retrieve:
press and hold down for several seconds release
delete: save:
Welding circuit resistance Welding circuit inductivity
Gas pre-fl ow time Gas post-fl ow time Slope (2-step, special 4-step) Starting current (2-step, special 4-step) Final current (2-step, special 4-step) Starting current duration (2-step) Final current duration (2-step) Threading speed Burn-back effect Length of wire before the safety cut-out trips Restoring factory setup 2nd menu level
Cooling unit control Cooling unit watchdog Country setting Welding circuit resistance Welding circuit inductivity Real Energy Input
MIG/MAG - setup Synergic
Hot-start current Hot-current time Anti-stick Restoring factory setup 2nd menu level
Rod electrode - setup
Quick Reference: English
TransSteel Synergic
press and hold
release
5 „Save“ buttons
Setup
2. Menu level for service engineers
e.g.: e.g.: e.g.:
e.g.:
e.g.: fi rmware version
welding program confi guration
number of the currently selected welding program motor current for wire drive in A The value changes as soon as the motor is running. Arc burning time