30
(2) Scales for sheet thickness
in mm
The two adjusters must be set to the appropriate value for the sheet thickness be-
ing used in order to obtain the basic setting according to the adjustment aid.
(3) Dynamic
Recommended dynamics settings are specified for three ranges of sheet thick-
ness.
Keylock A keylock can be selected to prevent the settings from being inadvertently changed on the
control panel. As long as the keylock is active
- no settings can be made on the control panel
- only parameter settings can be retrieved
Activate/deactivate the keylock as follows:
Keylock activated:
The message "CLO | SEd" appears on the displays.
Keylock deactivated:
The message "OP | En" appears on the displays.
Service parame-
ters
Various service parameters can be retrieved by pressing the "Dynamic" buttons at the
same time.
Opening the display
The first parameter ("Firmware version") is displayed, e.g. "1.00 | 4.21"
Selecting parameters
Available parameters
Press and hold the "Mode" button
Press the "Dynamic" button (right)
Release the "Mode" and "Dynamic" buttons
1
2
3
Press and hold the "Dynamic-" button
Press the "Dynamic+" button
Release the "Dynamic" buttons
Press the "Mode" and "Process" buttons to select the desired set-
up parameter
1
2
3
1
To Next Page
Loading...
