46
Connecting wire-feed unit to power source
General informa-
tion
The wire-feed unit is connected to the power source using the interconnecting hosepack.
Connecting wire-
feed unit to power
source
WARNING!
Fitting the equipment incorrectly can cause serious injury and damage.
Do not carry out the steps described here until you have read and completely understood
all the operating instructions.
NOTE!
When connecting the interconnecting hosepack, check that
► all connections are connected properly
► all cables, leads and hosepacks are undamaged and correctly insulated
1 2
IMPORTANT! To prevent wear and tear, form a loop towards the inside when connecting
the cables. A strain-relief device is not provided in the case of 1.2 m (3 ft. 11.24 in.) inter-
connecting hosepacks.
1
2
7
4
5
6
3
1
2
1
3
4
2
To Next Page
Loading...
