79
EN
Setup menu
General remarks The Setup menu provides simple access to expert knowledge in the power source and to
additional functions. The Setup menu can be used to make simple adjustments of the pa-
rameters to suit the various job settings.
Setup menu -
manual control
panel
Setting the setup parameters is described here with reference to the "MIG/MAG welding"
process. The procedure for changing other setup parameters is identical.
Accessing the setup menu
The control panel is now in the setup menu for the "MIG/MAG welding" process - the last
setup parameter that was selected is displayed.
Changing welding parameters
Exiting the setup menu
Setup menu -
Synergic A con-
trol panel
Setting the setup parameters is described here with reference to the "MIG/MAG standard
synergic welding" process. The procedure for changing other setup parameters is identi-
cal.
Accessing the setup menu
Use the "Process" button to select the "MIG/MAG welding" pro-
cess
Press the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
Use the "Mode" and "Process" buttons to select the required set-
up parameter
Use the "Dynamic" buttons to change the value of the setup pa-
rameter
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
1
2
3
4
5
6
7
8
9
Use the "Process" button to select the "MIG/MAG standard syn-
ergic welding" process
Press and hold the "Mode" button
1
2
To Next Page
Loading...
