Fronius VR 5000 - Page 80

80
The control panel is now in the setup menu for the "MIG/MAG standard synergic welding"
process - the last setup parameter that was selected is displayed.
Changing welding parameters
Exiting the setup menu
Press the "Process" button
Release the "Mode" and "Process" buttons
Use the "Mode" and "Process" buttons or the left-hand adjusting
dial to select the required setup parameter
3
4
5
Use the "Parameter selection" buttons or the right-hand adjusting
dial to change the value of the setup parameter
6
Press and hold the "Mode" button
Press the "Process" button
Release the "Mode" and "Process" buttons
7
8
9