What does 'Err | IP' mean on my Fronius VR 5000 Industrial Equipment?
The error code 'Err | IP' indicates that the control unit of the power source has detected a primary overvoltage. Check mains voltage, if the service code still remains, switch off the power source, wait for 10 seconds and then switch the power source on again.
What does 'Err | PE' mean on my Fronius VR 5000 Industrial Equipment?
The error 'Err | PE' means the earth current watchdog has triggered the safety cut-out of the power source. Switch off the power source, place it on an insulating surface, connect the grounding (earthing) cable to a section of the workpiece closer to the arc, wait 10 seconds, and switch the power source back on.
What does 'Err | Ur' mean on my Fronius VR 5000?
The error code 'Err | Ur' indicates that, if the VRD option is available, the open circuit voltage limit of 35 V has been exceeded. Switch off power source and wait for 10 seconds before switching it back on.
What does 'no | UrL' mean on my Fronius VR 5000?
The error 'no | UrL' means the VRD option has tripped too early. Check whether all welding power-leads and control lines are connected. Switch off the power source, wait 10 seconds and switch the power source back on again.
What does the 'E-Stop' error mean on my Fronius Industrial Equipment?
The 'E-Stop' error indicates that the "External stop" has tripped. Remedy the event that triggered the external stop.
What does 'PHA | SE' mean on my Fronius VR 5000 Industrial Equipment?
The error code 'PHA | SE' indicates a phase failure. Check the mains fuse, the mains lead, and the mains plug.
What does 'Mains undervoltage' mean on my Fronius Industrial Equipment?
The 'Mains undervoltage' error indicates that the mains voltage has fallen below the tolerance range. Check the mains voltage.
What does 'Mains overvoltage' mean on my Fronius Industrial Equipment?
The 'Mains overvoltage' error indicates that the mains voltage has risen above the tolerance range. Check the mains voltage.
What does 'no | H2O' mean on my Fronius VR 5000?
The error 'no | H2O' indicates that the coolant flow rate is too low. Check coolant flow rate and cooling unit, including cooling circuit.
What does 'hot | H2O' mean on my Fronius Industrial Equipment?
The error 'hot | H2O' indicates that the coolant temperature is too high. Allow cooling unit and cooling circuit to cool down until the error is no longer displayed. Open the cooling unit and clean the cooler, check the fan is working properly. Robot interface or field bus coupler: before resuming welding, set the "Source error reset" signal.
General| Brand | Fronius |
|---|---|
| Model | VR 5000 |
| Category | Industrial Equipment |
| Language | English |
To Next Page
