43
CAUTION! Risk of injury and damage from electric shock and from wire
electrode emerging from the torch. When you press the torch trigger:
- hold the torch so that it points away from your face and body
- do not point the welding torch at people
- make sure that the wire electrode does not touch any electrically conduc-
ting or earthed (grounded) parts, such as the housing, etc.
9. Press the torch trigger and start welding
Corrections
during welding -
Synergic A
control panel
To obtain the best possible welding results, the dynamic parameter will sometimes need
to be adjusted.
1. Press the „Parameter selection“ button and select the dynamic parameter
2. Use the adjusting dial to set the dynamic to the desired value
The parameter value is shown in the digital indicator located above it.
Arc-force dynamic
for influencing the short-circuiting dynamic at the instant of droplet transfer
0 harder, more stable arc
10 soft, low-spatter arc
MIG/MAG stan-
dard manual
welding - Syner-
gic A control
panel
(continued)
To Next Page
Loading...
