40
The MIG/MAG standard manual welding process is a MIG/MAG welding process with no
synergic function.
Changing one parameter does not result in any automatic adjustments to the other
parameters. All of the variable parameters must therefore be adjusted individually, as
dictated by the welding process in question.
MIG/MAG standard manual welding
General
The following parameters are available in MIG/MAG standard manual welding:
Wirefeed speed
1 m/min (39.37 ipm) - maximum wirefeed speed, e.g. 25.0 m/min (984.25 ipm)
Welding voltage
TSt 3500: 14.5 – 31.5 V
TSt 5000: 14.5 – 39 V
Arc-force dynamic
... for influencing the short-circuiting dynamic at the instant of droplet transfer
Welding current
only the actual value is displayed
Available parame-
ters
MIG/MAG stan-
dard manual
welding - manual
control panel
1. Press the Process button to select the desired welding process:
MIG/MAG welding
2. Press the Mode button to select the desired MIG/MAG mode:
2-step mode
4-step mode
Important! Parameters that have been set on a system component control panel
(e.g. remote control unit) may not be able to be changed on the wire-feed unit
control panel.
3. Set the required wire feed speed using the wire feed speed adjuster
4. Set the required welding voltage using the welding voltage adjuster
The parameter values are shown in the digital indicator located above them.
To Next Page
Loading...
