37
MIG/MAG welding
WARNING! An electric shock can be fatal. If the device is plugged into the
mains supply during installation, there is a high risk of very serious injury and
damage. Only carry out work on the device when
- the mains switch is in the „O“ position,
- the device is unplugged from the mains.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read
and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
Safety
General tasks
before MIG/MAG
welding
1. Only where a cooling unit and water-cooled welding torch are used:
Connect the water hoses of the welding torch to the correct plug-type connectors on
the wirefeeder
2. Plug in the mains plug
3. Move the mains switch to the „I“ position:
- All the indicators on the control panel light up briefly
- where applicable, the cooling unit starts to run
Important! Follow the safety rules and note operating conditions in the cooling unit
operating instructions.
Overview „MIG/MAG welding“ is composed of the following sections:
- MIG/MAG standard synergic welding
- MIG/MAG standard manual welding
- Special functions and options
To Next Page
Loading...
