46
Adjustments
while welding -
Synergic A
control panel
Hotstart function
To obtain optimum welding results, it will sometimes be necessary to adjust the Hotstart
function.
Advantages
- Improved ignition, even when using electrodes with poor ignition properties
- Better fusion of the base metal in the start-up phase, meaning fewer cold-shut
defects
- Largely prevents slag inclusions
For details on setting the available parameters, please refer to „Set-up parameters“,
„Set-up menu - level 2“.
In order to obtain the best possible welding results, the following parameter can be
corrected in certain circumstances:
1. Press the „Parameter selection“ button and select the dynamic correction parameter
2. Use the adjusting dial to set the dynamic correction to the desired value
The parameter value is shown in the digital indicator located above it.
Arc-force dynamic
for influencing the short-circuiting amperage at the instant of droplet transfer
0 harder, more stable arc
100 soft, low-spatter arc
MMA welding -
Synergic A
control panel
(continued)
3. Press the „Parameter selection“ button and select the welding current parameter.
4. Use the adjusting dial to set the desired amperage.
The amperage value is displayed in the left-hand digital display.
All parameter command values that have been set by means of the adjusting dial
will remain stored until the next time they are changed. This applies even if the
power source is switched off and on again in the meantime.
5. Start welding
To Next Page
Loading...
