23
Before commissioning
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read
and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
WARNING! A machine that topples over or falls from its stand can easily kill
someone. Place devices, upright consoles and trolleys on a solid, level
surface in such a way that they remain stable. If a swivel pin holder is being
used, make sure that the wirefeeder is seated securely on the swivel pin.
Setup regulations
The device is intended exclusively for wire feeding in MIG/MAG welding.
Utilisation for any other purpose, or in any other manner, shall be deemed to be „not in
accordance with the intended purpose“. The manufacturer shall not be liable for any
damage resulting from such improper use.
Utilisation in accordance with the „intended purpose“ also includes
- following all the instructions in this manual
- carrying out all the specified inspection and servicing work
Utilisation in
accordance with
„intended purpo-
se“
Safety
WARNING! An electric shock can be fatal. If the device is plugged into the
mains supply during installation, there is a high risk of very serious injury and
damage. Only carry out work on the device when
- the mains switch is in the „O“ position,
- the device is unplugged from the mains.
To Next Page
Loading...
