Fronius VR 5000 - MIG;MAG Modes; General; Symbols; 2 Step Mode

35
MIG/MAG modes
For details of the meaning, setting, setting range and units of the available parameters
(e.g. GPr), please refer to the section entitled „Set-up parameters“.
Press the torch trigger Hold the torch trigger Release the torch trigger
Press torch trigger symbol Hold torch trigger symbol Release torch trigger symbol
General
Symbols
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read
and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
„2-step mode“ is suitable for
- tacking-work
- short seams
- automatic and robot welding
2-step mode
2-step mode
t
I
+
I
GPr GPo