18
Wirefeeder side
VR 5000 - side view
No. Function
(1) Wirespool holder with brake
for holding standard wirespools with a max. diameter of 300 mm (11.81 in) and max.
weight of 19 kg (41.89 lbs.)
(2) Synergic control panel section B
- in conjunction with the Synergic control panel
(3) 4 roller drive
(4) „Feeder inching“ / „Gas test“ button - option
Push button downwards:
to feed the wire electrode into the welding torch hosepack with no accompanying
flow of gas or current. While the button is being held down, the wire-feed unit runs at
feeder inching speed.
Push button upwards:
to set the required quantity of gas at the pressure regulator.
- Tap button once: protective gas flows out
- Tap button again: protective gas flow stops
If the „Gas test“ button is not tapped again, the protective gas flow will stop after 30 s.
(1) (2) (4)(3)
To Next Page
Loading...
