Fronius VR 5000 - General; Mode Set-Up Menu; Mode Set-Up Menu - Synergic a Control Panel

54
Setting the Mode parameters is described by reference to „Special 4-step mode - S 4 T“
for the Synergic A control panel.
Enter the Mode set-up menu
Mode set-up
menu - Synergic
A control panel
The Mode set-up menu provides simple access to expert knowledge in the power source
and to additional functions. The Mode set-up menu can be used to make simple adjust-
ments of the parameters to the various job settings.
Mode set-up menu
General
The control panel is now in the set-up menu for „Special 4-step mode - S 4 T“ - the last
parameter that was selected is displayed.
Changing a parameter
1. Use the Mode button to select „Special 4-step mode - S 4 T“
2. Press and hold the Mode button
3. Press the Process button
4. Release the Mode and Process buttons
5. Select the required parameter using the Mode and Process
buttons or the left adjusting dial
Exiting from the set-up menu
7. Press and hold the Mode button
8. Press the Process button
9. Release the Mode and Process buttons
6. Change the value of the parameter using the Parameter Selec-
tion button or the right adjusting dial