32
Commissioning
Requirements When commissioning the wirefeeder, the following requirements must be met:
- Wirefeeder connected to the power source using the interconnecting hosepack
- Welding torch connected to wirefeeder
- Feed rollers inserted in the wirefeeder
- Wirespool or basket-type spool and adapter inserted in the wirefeeder
- Wire electrode fed in
- Braking force set
- Feed roller contact pressure set
- All covers closed, all side panels in place, all protection devices intact and in their
proper place
General
The wirefeeder is commissioned by pressing the torch trigger (for manual applications)
or by means of a welding start-up signal (for automatic applications).
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read
and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
To Next Page
Loading...
