Fronius VR 5000 - Manual Control Panel Functions

12
No. Function
(1) „Process“ button
for selecting the process
MIG/MAG welding
STICK - MMA welding
to select parameters in the Set-up menu
(2) „Mode“ button
for selecting the mode
2-step mode
4-step mode
to select parameters in the Set-up menu
(3) Welding voltage adjuster
for selecting the welding voltage in V
The welding voltage is directly related to the length of the arc.
(4) Wirefeed speed adjuster
for selecting the wirefeed speed in m/min or ipm.
If the welding voltage remains (3) constant, the welding current increases as the
wirefeed speed (4) increases.
Manual control panel
Manual control
panel
Manual control panel
General The Manual control panel allows welding parameters to be set manually in a very
straightforward process.
(2) (1)
(3)
(4)
(5)
(5)
(6)