Fronius VR 5000 - Description of Control Panels

11
Description of the control panels
General The functions on the control panels are all arranged in a very logical way. The various
parameters needed for welding are easy to select, by pressing the appropriate button,
and can easily be
- altered using buttons or the adjusting dial
- displayed on the digital display during welding
Thanks to the synergic function, whenever you alter any one parameter, appropriate
changes will automatically be made to all the other parameters.
NOTE! Owing to software updates, you may find that your device has certain
functions that are not described in these operating instructions, or vice versa.
Certain illustrations may also differ slightly from the actual control elements on
your device. However, these control elements function in exactly the same way.
Important! Parameters that must be entered at a wirefeeder control panel cannot be
changed at the power source. Parameters can only be changed at the wirefeeder.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read
and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
Safety