25
Connecting wirefeeder to power source
General
Connecting
wirefeeder to
power source
The wirefeeder is connected to the power source using the interconnecting hosepack.
Important! To prevent wear and tear, form a loop towards the inside when connecting
the cables. A strain-relief device is not provided in the case of 1.2 m (3 ft. 11.24 in.)
interconnecting hosepacks.
NOTE! When connecting the interconnecting hosepack, check that
- all connections are connected properly
- all cables, leads and hosepacks are undamaged and correctly insulated
WARNING! Fitting the equipment incorrectly can cause serious injury and
damage. Do not carry out the steps described here until you have read and
completely understood all the operating instructions.
1
1
2
3
6
7
4
5
2
1
2
3
4
To Next Page
Loading...
