Fronius VR 5000 - Process Set-Up Menu - Synergic a Control Panel

52
Process set-up
menu - Synergic
A control panel
Setting process parameters is described here with reference to the MIG/MAG standard
synergic welding process. The procedure for changing other process parameters is
identical.
Open the Process set-up menu
1. Use the „Process“ button to select the MIG/MAG standard
synergic welding process
2. Press and hold the Mode button
3. Press the Process button
4. Release the Mode and Process buttons
The control panel is now in the set-up menu for the „MIG/MAG standard synergic wel-
ding“ process - the last parameter that was selected is displayed.
Changing a parameter
5. Select the required parameter using the Mode and Process
buttons or the left adjusting dial
6. Change the value of the parameter using the Parameter Selec-
tion button or the right adjusting dial
Exiting from the set-up menu
7. Press and hold the Mode button
8. Press the Process button
9. Release the Mode and Process buttons