5-10
*6 The value in parentheses ( ) for H95 denotes the default setting for the EU version.
If initialized by H03, the H95 data reverts to "1" in the EU version.
(Note 1) Function code H71 appears on the LED monitor; however, the FRENIC-Mini series of inverters does not
recognize this code.
(Note 2) Function code H95 is valid on inverters with ROM version C1S11000 or later. (The lowest four digits of
the ROM version can be displayed on the LED monitor. For details, refer to Chapter 3, Section 3.2.2 [5]
"Reading maintenance information."
To Next Page
Loading...
