Fuji Electric Frenic - Changing Inverter Model Data; Converting Function Code Data Between Models

Chapter 2 Description of Functions
61
[ 1 ] Change models（VG7 → VG1, or VG1 → VG7）
To use the function code data read from the inverter of "FRENIC-VG7" for the inverter of
"FRENIC-VG", it is necessary to change a "model" into "VG1" from "VG7."
It is also the same as when using the function code data of "VG1" for "VG7."
The function code which exists in the model before conversion and does not exist in the model
after conversion is displayed on the dialog of a file reading error.
(The following figure is a case where it changes into "VG1" from "VG7".)
･ Change models (VG7 → VG1/VG1 → VG7) is only possible if the standard or
semi-standard(CC,SX,FB) products.