[ 2 ] Change of inverter capacity
Change the "capacity inverter" of the current function code list.
It will be changed into the value of the capacity as which the "preset value" of the
following function code and the "factory-shipments value" were chosen if "Inverter
capacity" is changed.
Function
code
Name
Function
code
Name
F04 M1 Maximum Speed P15 M1 Magnetic Saturation Factor 1
F05 M1 Rated Voltage P16 M1 Magnetic Saturation Factor 2
F11
M1 Electronic Thermal Overload
Protection (Detection level)
P17 M1 Magnetic Saturation Factor 3
F12
M1 Electronic Thermal Overload
Protection (Thermal time constant)
P18 M1 Magnetic Saturation Factor 4
F26 Motor Sound (Carrier frequency) P19 M1 Magnetic Saturation Factor 5
P02 M1 Motor Selection P20 M1 Secondary Time Constant
P03 M1 Rated Capacity P21 M1 Induced Voltage Factor
P04 M1 Rated Current P22 M1 R2 Correction Factor 1
P05 M1 Number of Poles P23 M1 R2 Correction Factor 2
P06 M1 %R1 P24 M1 R2 Correction Factor 3
P07 M1 %X P25
M1 Exciting Current Correction
Factor
P08
M1 Exciting Current/Magnetic Flux
Weakening Current (-Id)
P33
M1 Maximum Output Voltage/
Maximum Voltage Limit
P09 M1 Torque Current H15
Restart Mode after Momentary
Power Failure
(Continuous running level)
P10 M1 Slip Frequency (For driving) H51 Observer (M1 load inertia)
P11 M1 Slip Frequency (For braking)
P12 M1 Iron Loss Factor 1
P13 M1 Iron Loss Factor 2
P14 M1 Iron Loss Factor 3
62
To Next Page
Loading...
