Fuji Electric Frenic - Input Signal Selection for Monitoring; Input Terminal Signal Options

Chapter 2 Description of Functions
85
Signal selection block
Y: Available, N: Not available
Signal selection block Trace back
Real-tim
e trace
/ Historical trace
Input terminal (FWD, REV, X1 – X14, RST) Y: Low speed Y
Input 1 X terminal function (0 – 15) N Y
Input 2 X terminal function (16 – 31) N Y
Input 3 X terminal function (32 – 47) N Y
Input 4 X terminal function (48 – 63) N Y
Input 5 X terminal function (64 - 79) N Y
Operation status Y: Low speed N
Output terminal (Y1 – Y4, RY, X11 – X18) Y: Low speed Y
Output 1 Y terminal function (0 – 15) Y: Low speed Y
Output 2 Y terminal function (16 – 31) Y: Low speed Y
Output 3 Y terminal function (32 – 47) Y: Low speed Y
Output 4 Y terminal function (48 – 63) Y: Low speed Y
Output 5 Y terminal function (64 - 79) Y: Low speed Y
Output 6 Y terminal function (80 - 95) Y: Low speed Y
Signal selection
The information items of the inverters that can be monitored are as shown below.
Signal selection block “Input terminal (FWD, REV, X1 - X14, RST)” items
No Item
0 FWD(Forward run command)
1 REV(Reverse run command)
2 X1
3 X2
4 X3
5 X4
6 X5
7 X6
8 X7
9 X8
10 X9
11 X11
12 X12
13 X13
14 X14
15 RST(RESET command)