88
Signal selection block “Output terminal (Y1 - Y5, Y11 - Y18)” items
No Item
0 Y1
1 Y2
2 Y3
3 Y4
4 Y5
5 Y11
6 Y12
7 Y13
8 Y14
9 Y15
10 Y16
11 Y17
12 Y18
13 -
14 -
15 -
Signal selection block “Output 1 Y terminal function (0 - 15)” items
No Item
0 0:Inverter running[RUN]
1 1:Speed existence signal[N-EX]
2 2:Speed agreement 1[N-AG1]
3 3:Speed arrival signal[N-AR]
4 4:Speed level detection 1[N-DT1]
5 5:Speed level detection 2[N-DT2]
6 6:Speed level detection 3[N-DT3]
7 7:Stopping on undervoltage[LU]
8 8:Detected TRQ. polarity(Brake/Drive)[B/D]
9 9:Torque limiting[TL]
10 10:Torque detection 1[T-DT1]
11 11:Torque detection 2[T-DT2]
12 12:KEYPAD operation mode[KP]
13 13:Inverter stopping[STOP]
14 14:Operation ready output[RDY]
15 15:Magnetic-flux detection[MF-DT]
Signal selection block “Output 2 Y terminal function (16 - 31)” items
No Item
0 16:Motor M2 selected[SW-M2]
1 17:Motor M3 selected[SW-M3]
2 18:Brake release signal[BRK]
3 19:Alarm content 1[AL1]
4 20:Alarm content 2[AL2]
5 21:Alarm content 4[AL4]
6 22:Alarm content 8[AL8]
7 23:Cooling fan in operation[FAN]
8 24:Resetting[TRY]
9 25:Universal DO[U-DO]
10 26:Heat sink OH. early warning[INV-OH]
11 27:Synchronization completion[SY-C]
12 28:Lifetime alarm[LIFE]
13 29:Under acceleration[U-ACC]
14 30:Under deceleration[U-DEC]
15 31:Inverter OL. early warning[INV-OL]
To Next Page
Loading...
