Chapter 2 Description of Functions
89
Signal selection block “Output 3Y terminal function (32 - 47)” items
No Item
0 32:Motor OH. early warning[M-OH]
1 33:Motor OL. early warning[M-OL]
2 34:DB OL. early warning[DB-OL]
3 35:Link transmission error[LK-ERR]
4 36:Load adaptive control under limit[ANL]
5 37:Load adaptive control under calc.[ANC]
6 38:Analog torque bias hold[TBH]
7 39:Custom Do1[C-DO1]
8 40:Custom Do2[C-DO2]
9 41:Custom Do3[C-DO3]
10 42:Custom Do4[C-DO4]
11 43:Custom Do5[C-DO5]
12 44:Custom Do6[C-DO6]
13 45:Custom Do7[C-DO7]
14 46:Custom Do8[C-DO8]
15 47:Custom Do9[C-DO9]
Signal selection block “Output 4Y terminal function (48 - 63)” items
No Item
0 48:Custom Do10[C-DO10]
1 49: -
2 50:Z phase detection completed[Z-RDY]
3 51:Multiplex sys. com. establishment[MTS]
4 52:Multiplex sys. cancel response[MEC-AB]
5 53:Master selected[MSS]
6 54:Multiplex system self-alarm[AL-SF]
7 55:Communication error stop[LES]
8 56:Alarm output (for any alarm)[ALM]
9 57:Light alarm[L-ALM]
10 58:Maintenance timer[MNT]
11 59:DB transistor error[DBAL]
12 60:DC fan locked[DCFL]
13 61:Speed agreement 2[N-AG2]
14 62:Speed agreement 3[N-AG3]
15 63:Electric motor fan stop[MFAN]
Signal selection block “Output 5Y terminal function (64 - 79)” items
No Item
0 64:Assign ready[AS-RDY]
1 65: -
2 66:Droop answer back[DSAB]
3 67:TRQ.(current) ref. cancel response[TCL-C]
4 68:TRQ. limit 1 cancel response[F40-AB]
5 69: -
6 70: -
7 71:73-on reference[PRT-73]
8 72:Y terminal test ON[Y-ON]
9 73:Y terminal test OFF[Y-OFF]
10 74: -
11 75:Clock battery life[BATT]
12 76:Tune in Pole position[TUN-MG]
13 77:SPGT battery warning[SPGT-B]
14 78: -
15 79: -
To Next Page
Loading...
