4-30
Section 4 Software Interface
4-3 Analog Input/Output Module
2) When scaling parameter read mode is activated
15(F) 0
+3
+2
Offset value
Gain value
* When using D300win, assign INT type variables to these registers.
3) When operation range parameter read mode is activated
15(F) 0
+2
+3
Unused (fixed to 0 (zero))
CH4 CH3 CH2
CH1
CH5CH6
Analog output operation range
Analog input operation range
OFF/OFF/OFF/OFF
OFF/OFF/OFF/ON
OFF/OFF/ON/OFF
OFF/OFF/ON/ON
OFF/ON/OFF/OFF
OFF/ON/OFF/ON
OFF/ON/ON/ON
Others
: 0 to 10 V
: 0 to 5 V
: 1 to 5 V
: -10 to 10 V
: 4 to 20 mA
: 0 to 20 mA
: -20 to 20 mA
: 0 to 10 V
4) When offset/gain adjustment mode is activated
* When using D300win, assign a WORD type variable to this register (offset address +2). If you access by the bit, assign a
BOOL type variable to each bit.
15(F) 0
+2
Unused (fixed to 0 (zero))
Analog input
OFF:
ON:
Analog output
OFF:
ON:
ON: Down is specified.
ON: Up is specified.
For analog input
ON: Writing to module internal EEPROM
For analog output
ON: Writing to module internal EEPROM
+3
AD converted value
AD converted value (INT type)
(A converted value of a channel specified by the affset address +6 can be monitored.)
* When using D300win, assign an INT type variable to this register.
Offset value is displayed
Gain valu is displayed
Offset value is displayed
Gain valu is displayed
To Next Page
Loading...
