Fuji Electric MONITOUCH TS Series - Setting Local Port Number

5-42 2. Main Menu Screen
11-1. Setting Local Port Number
For V-Link, Modbus slave or multi-link communication, set the local port number from the Main Menu
screen.
(The local port number can be set when [Set Local Port No. in Main Menu] is checked with [PLCn:
V-Link] or [PLCn: Modbus Slave (RTU)] selected in the [Device Communication Setting] dialog
([System Setting] → [Device Connection Setting]) or with [Connection Mode: Multi-link] selected in the
[Communication Setting] tab window ([System Setting] → [Device Connection Setting] →
[Communication Setting]) on the V-SFT-5 editor.
1. Displaying the [Local No.] field:
Press the [Down] switch to display the [Local No.] field.
2. Setting the local port number:
Select a local port number using the [+] or [−] switch. The local port number can be selected from
1 to 254.
Press the [Setting Finished] switch to complete the setting.
3. The Main Menu screen is automatically displayed again.
Local port number setting screen Setting completed