Fuji Electric MONITOUCH TS Series - Date and Time Adjustment; Formatting SRAM

5
2. Main Menu Screen 5-13
TS Series Operations
5-1. Date and Time Adjustment
This screen is used for correcting the built-in clock of the TS series.
To use the built-in clock of the TS series, check [Use Built-in Clock] in the [SRAM/Clock Setting] dialog
that is displayed by selecting [System Setting] → [Unit Setting] → [SRAM/Clock] on the V-SFT-5 editor.
1. Move the cursor using the [←] and [→] switches. Correct the date and time using the [+] and [−]
switches.
2. Press the [Set] switch to determine the setting. The clock displayed on the upper right is modified.
3. Pressing the [Return] switch displays the Main Menu screen again.
5-2. Formatting SRAM
An SRAM area can be formatted.
When the SRAM area is formatted, the contained data (historical data saved in SRAM, internal
memory $L, etc.) is cleared. Double-check before formatting the SRAM.
1. Press the [Format] switch and the [Execute] switch.
The SRAM area is formatted in the current screen data format. When formatting has been
completed, the message “∗∗Format Completed∗∗” is displayed.
2. Pressing the [Return] switch displays the Main Menu screen again.
After change
Before change
Format of the SRAM area completed
Before formatting the SRAM area