Fuji Electric MONITOUCH TS Series - Interface, Clock, and Backup Memory Specs

2
1. Specifications 2-3
Specifications
Interface Specifications
*1 Use DIP switches to switch between RS-422 (4-wire connection) and RS-485 (2-wire connection). For more
information, refer to page 4-6.
*2 For more information, refer to the TS Series Connection Manual.
*3 The same connector is used for RS-232C and RS-485 (2-wire connection) ports. Communicating via RS-232C
(COM2) and RS-485 (COM3) can take place at the same time.
*4 Provided as standard for TS1100i and TS1070i only
*5 Both straight and cross cables are usable, irrespective of the presence or absence of a hub.
Clock and Backup Memory Specifications
* The range of deviation may increase, depending on the ambient temperature. Check and correct the clock
periodically.
Item Specifications
D-sub 9-pin
(COM1/2/3)
COM1
Applicable
Standards
RS-422 (4-wire connection) / RS-485 (2-wire connection)
*1
Synchronization Asynchronous type
Data Length 7- or 8-bit
Parity None, odd, even
Stop Bit 1- or 2-bit
Baud Rate
4800, 9600, 19200, 38400, 57600, 76800, 115 Kbps
(For PPI/MPI connection with a Siemens PLC: 187.5 Kbps
*2
)
Applications PLC, temperature controller, etc.
COM2
COM3
Applicable
Standards
COM2: RS-232C / COM3: RS-485 (2-wire connection)
*3
Synchronization Asynchronous type
Data Length 7- or 8-bit
Parity None, odd, even
Stop Bit 1- or 2-bit
Baud Rate 4800, 9600, 19200, 38400, 57600, 76800, 115 Kbps
Applications PLC, temperature controller, barcode reader, etc.
USB Connector
(USB-A / B)
USB-A
Applicable
Standards
USB versions 2.0 and 1.1
Baud Rate
Version 2.0: High-speed 480 Mbps
Version 1.1: Low-speed 1.5 Mbps, full-speed 12 Mbps
Applications
Printer (EPSON STYLUS PHOTO series), USB memory, USB-CFREC,
keyboard, mouse, etc.
USB-
miniB
Applicable
Standards
USB versions 2.0 and 1.1
Baud Rate
Version 2.0: High-speed 480 Mbps
Version 1.1: Low-speed 1.5 Mbps, full-speed 12 Mbps
Applications Screen data transfer, PictBridge-compatible printer
Ethernet Port
100BASE-TX /
10BASE-T
(LAN)
*4
Applicable Standards IEEE802.3u (100BASE-TX), IEEE802.3 (10BASE-T)
Baud Rate 10 Mbps, 100 Mbps
Protocol TCP/IP, UDP/IP
Functions Auto-MDIX
Recommended cable
*5
100 Ω UTP (unshielded twist-pair cable), category 5, max. 100 m long
Applications Screen data transfer, PLC, etc.
Item Specifications
Battery Specification Coin-type lithium primary cell (CR2032)
Backup Memory SRAM 128 kbytes
Backup Period 3 years from the date of manufacturing (ambient temperature at 25 °C)
Calendar Accuracy
Monthly deviation ±5 sec (ambient temperature at 25 °C)
*