Fuji Electric MONITOUCH TS Series - IP Address Setting for the TS Series

5
2. Main Menu Screen 5-9
TS Series Operations
4-1. IP Address Setting for the TS Series
For communicating via Ethernet, set the IP address for the TS unit. An IP address can be set either on
the TS unit or in screen data using the V-SFT editor.
Setting on the TS Unit
1. Press the [Ethernet] switch on the Main Menu drop-down window to display the Ethernet screen.
2. Press the [EDIT] switch and set each item.
3. Press the [Setting Finished] switch to determine the IP address. Check the IP address displayed
under [Ethernet Information] on the Main Menu screen.
It is not used when the gateway or the subnet mask is zero.
Before change
Change the IP address using the keypad.
Determine the IP address setting.