3
1. Mounting Procedure 3-1
Installation
1. Mounting Procedure
Mounting Procedure
1. Insert the TS unit into the mounting panel (max. thick: 5 mm).
* When using an optional waterproof gasket “TS1xx0-WP”, firmly sandwich the gasket between
the mounting panel and the TS series.
2. Fit the supplied four fixtures onto the screws of the TS series. Tighten them with the supplied four
nuts. (Tightening torque: 0.3 to 0.4 N•m)
* When the TS unit is attached to the mounting panel, the fixtures and frame grounds (FG) are
connected.
X
Y
TS1100
TS1070
X
Y
257.0
+0.5
-0
189.0
+0.5
-0
X
199.0
+0.5
-0
134.0
+0.5
-0
YModel
Panel cut-out dimensions
Unit: mm
Panel cut-out hole
Mounting panel
4.2
8.5
8.5
17.5
17.5
8
14.0
•Fixture
dimensions
Fixture
Nut
Screw
• Dimensions of a tightened fixture that lies off the edges of the
TS unit
Back of the TS unit
Mounting panel
(Unit: mm)
• Nut dimensions
To Next Page
Loading...
