Preface
Thank you for selecting the Techno Shot series (TS series).
For correct set-up of the TS series, you are requested to read through this manual to understand more about the
product.
The manuals shown below are related manuals for the TS series. Refer to them as necessary.
For further details about controllers (PLCs, temperature controllers, etc.), refer to the manual issued by each
controller manufacturer.
Manual Name Contents Reference No.
TS Series Training Manual Screen configuration procedures using V-SFT
version 5 are explained with examples.
1203NE
TS Series Connection Manual Connecting the TS series with controllers and
setting their communication parameters are
explained.
2203NE
V8 Series Reference Manual The functions and instructions of the V8 series are
explained.
1055NE
V8 Series Reference: Additional Functions Additional functions and operations of the V8
series that are available with V-SFT version
5.1.0.0 and later are explained.
1060NE
V Series Macro Reference An overview of macros as well as macro editor
operations and macro command descriptions are
explained in detail.
1056NE
V8 Series Operation Manual Information related to the operations of V-SFT
version 5, such as software composition, editing
procedure or limitations, is explained.
1058NE
Notes:
1. This manual may not, in whole or in part, be printed or reproduced without the prior written consent of
Hakko Electronics Co., Ltd.
2. The information in this manual is subject to change without prior notice.
3. Windows and Excel are registered trademarks of Microsoft Corporation in the United States and other
countries.
4. All other company names or product names are trademarks or registered trademarks of their
respective holders.
5. If the specifications of the software do not correspond with the contents of this manual, the software
specifications have priority.
To Next Page
Loading...
