Fuji Electric MONITOUCH TS Series - Page 90

5-32 2. Main Menu Screen
CTS/RTS Test
Check the signals [CTS] and [RTS].
1. Install a jumper between pins 7 (RTS) and 8 (CTS) of COM2 on the TS series.
2. Press the [COM2] switch in the [Communication Port] field. The [RS232C] lamp comes on.
3. Press the [RTS] switch and check that both [RTS] and [CTS] lamps light up at the same time.
Press the [RTS] switch again and check that both [RTS] and [CTS] lamps go off at the same
time.
CTS
RTS 7
8
Name No.