5-36 2. Main Menu Screen
Touch Switch Adjustment
If a position different from the pressed position turns white on the touch switch test screen, follow the
steps described below to adjust the touch switch position.
1. Press the [Adjust] switch on the touch switch test screen. The Touch Switch Adjustment screen
appears.
2. Press on “1” that is flashing at the corner. When
the finger is released, a beep sounds and the
position is set. “2” flashes.
3. Press on “2” that is flashing at the corner. When
the finger is released, a beep sounds and the
position is set. “3” flashes.
4. Press on “3” that is flashing at the corner. When
the finger is released, a beep sounds and the
position is set. “4” flashes.
5. Press on “4” that is flashing at the corner. When
the finger is released, a beep sounds and the
position is set.
6. To re-set the positions, press the
[Reset] switch and follow step 2 and
later.
7. To cancel the setting, press the
[Return] switch. The touch switch
test screen is displayed again.
8. To determine the setting, press the
[Fix] switch. A long beep sounds and
the positions are determined. The
touch switch test screen is displayed
again.
Touch switch test screen
Touch Switch Adjustment screen
To Next Page
Loading...
