Replacing Consumables
101
Maintenance
3
11
Close the finisher front door.
z
If the front door is not closed completely, a message appears and the machine will remain paused.
Emptying the Hole Punch Waste Container (for Finisher B1)
When the optional Finisher B1 is installed and the hole punch waste container becomes full,
a message appears on the touch screen. When the message appears, empty the hole punch
waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
z
Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
z
When the
machine is i
n the Power
Saver mode,
exit the Power
Saver mode by pr
essing the
<Power S
aver>
button and the <Machine Status> button on the control panel before you empty the hole punch waste
container.
z
When emptying the punch waste container, press the <Machine Status> button and check the current status
for the hole punch waste container even when the control panel is lit.
1
Make sure that the machine is not operating, and open the front cover.
2
Lift the top transport cover, and then open the front transport cover of the finisher.
To Next Page
Loading...
Need help?
General
