Problem Solving
702
Problem Solving
15
5
Remove the jammed staples (1), and then return the metal part pulled up in step 4 to the
original position (2).
6
Push the staple cartridge into the machine until it clicks into place.
7
Close the finisher front cover.
z
If the finisher front cover is not completely closed, a message will appear and the machine remains paused.
If you cannot remove jammed staples even after you perform the above procedure,
contact our Customer Support Center.
Staple Jams in Staple Cartridge (For Finisher B1)
This section describes how to clear staple jam occurred in the staple cartridge of the
Finisher B1 (optional).
1
Make sure that the machine is not operating, and open the finisher front cover.
Be careful in removing jammed staples.
To Next Page
Loading...
Need help?
General
