Cleaning the Machine
115
Maintenance
3
Cleaning the Document Feeder Rollers
If the document feeder rollers become soiled, smudges may appear on copies, faxes, or
scanned documents and paper jams may occur.
To ensure clean copies at all times, clean the document feeder roller about once a month.
z
Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint or coating on
plastic parts.
z
Cleaning the machine with an excessive amount of water may cause the machine to malfunction or damage
documents during copying, faxing, scanning, or printing.
With Duplex Automatic Document Feeder B1-PC
1
Pull up the handle of the left cover of the document feeder, and then open the left cover
until it stops.
z
When you fully open the cover, it enters a fixed position. Open the cover gently.
2
While turning the rollers, wipe them with a soft cloth moistened with water.
z
Do not use cleaning agents other than water or neutral detergent.
z
Use a cloth firmly wrung to prevent water drops from falling into the machine. If water gets into the machine,
it may cause the machine to malfunction.
z
If you cannot remove dirt easily, gently wipe the rollers with a soft cloth moistened with a small amount of
neutral detergent.
3
Close the left cover of the document feeder until it clicks into place, and confirm that there
is no space between the near or far side of the cover and the document feeder.
To Next Page
Loading...
Need help?
General
