Replacing Consumables
103
Maintenance
3
Emptying the Hole Punch Waste Container (for C3 Finisher or C3
Finisher with Booklet Maker)
When the C3 Finisher (optional) or the C3 Finisher with Booklet Maker (optional) is installed
and the hole punch waste container becomes full, a message appears on the touch screen.
When the message appears, empty the hole punch waste container as instructed.
z
Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
z
Empty the hole punch waste container after the message appears. Otherwise, the machine cannot recognize
the correct remaining amount of the punch scraps.
z
Make sure to discard all paper chads when emptying the hole punch waste container. Not doing so will cause
the container to fill up before the message telling you to empty the container appears again, and this can
cause machine malfunction.
z
When the machine is in Power Saver mode, exit Power Saver mode by pressing the <Power Saver> button and
the <Machine Status> button on the control panel before you empty the punch waste container.
z
Before emptying the punch waste container, press the <Machine Status> button and check the current status
for the punch waste container even when the control panel is lit.
1
Make sure that the machine is not operating, and open the finisher front door.
2
Pull out the hole punch waste container [R4].
3
Empty the container.