Fuji Xerox ApeosPort-VI C4471

Tools
250
Tools
5
UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important
z
Do not use any numbers assigned to other ports.
TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important
z
Do not use any numbers assigned to other ports.
RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important
z
Do not use any numbers assigned to other ports.
Prioritize IP Packets / Prioritize IP Packets (Ethernet 1), Prioritize IP Packets (Ethernet 2)
Set the priority of IP packet transmission from 0 to 255.
Note
z
The value set varies depending on your environment. Consult your network administrator.
z
Set the value already specified by the network side. If you set other values, the priority does not change.
(For most of Cisco
®
routers, speech traffic is set to 184(ef). If you change the value, consult your network
administrator.)
z
The title of this setting item differs depending on the Ethernet interface configuration: When single Ethernet
interface is used, [Prioritize IP Packets] is displayed. When two Ethernet interfaces are used, [Prioritize IP
Packets (Ethernet 1)] and [Prioritize IP Packets (Ethernet 2)] are displayed.
z
When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network Name], the
specified names are displayed instead of "Ethernet1" and "Ethernet2" of [Prioritize IP Packets (Ethernet 1)]
and [Prioritize IP Packets (Ethernet 2)] respectively.
Outgoing/Incoming E-mail Settings
Set e-mail transmission and reception settings.
POP3 Server Settings
Set the POP3 server. In [POP3 Server Settings], you can set the following items:
 Server Name/IP Address
Enter a server name or IP address with up to 256 characters, and then select [Save].
Note
z
For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from 0 to 255.
z
For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a
hexadecimal value.
 Port Number
Enter a port number from 1 to 65535.
The default value is 110.
Important
z
Do not use the numbers assigned to the other ports.