Appendix
818
Appendix
16
Print control 159
(Scaling)
Sets whether the original size is enlarged or reduced so that the document
size fits the paper size.
[0]: OFF
[1] (Default) : ON
160
(Scaling mode)
Selects the document size for auto scaling: A series paper (A0, A1, A2, A3, A4,
and A6) or the active coordinate area which is determined accordance with
the setting selected in [Area Determination Mode].
[0] (Default) : Paper Size
[1] : Active Coordinate Area
z
[Active Coordinate Area] can be selected only when [Auto layout] is set to [ON].
When [OFF] is selected, [Scaling mode] becomes [Paper Size].
z
The setting of the scaling mode is valid when [Document size] is set to [Auto].
161
(Active area
determination
command)
Sets the method to obtain the active coordinate area when auto scaling is
being used.
[0] (Default) : Auto
[1]: PS
[2]: IW
[3]: IP
[4]: Adapted
z
The setting of the active area determination command is valid when [Document
size] is set to [Auto].
162
(Paper margin)
Sets the paper margin when auto scaling is being used.
[0] - [99] (Default: 0) : 0 to 99 mm
z
The setting of the paper margin is valid when [Document size] is set to [Auto].
163
(Image
enhancement)
Sets whether to perform image enhancement, which artificially increases the
resolution of an image and smooth its edges.
[0]: OFF
[1] (Default) : ON
Stapling 164 Sets the stapling position.
[0] (Default) : None
[1]: Top Left
[2]: Top Double
[3]: Top Right
[4]: Left Double
[5]: Right Double
[6]: Bottom Left
[7]: Bottom Double
[8]: Bottom Right
[9]:Center
Manual feed tray
check indicator
165 [0]:None
[1] (Default): Yes
Punching 166 Select the position for punching holes.
[0](Default): None
[1]: Top
[2]: Bottom
[3]: Left
[4]: Right
Parameter Item No. Value
To Next Page
Loading...
