5 Copy
128
Operations during Copying
Canceling a Copy
1
Tap [Pause].
2
Tap [Delete].
Copying Next Original
The following describes the operation when you have added the check mark to [Next
Original] on the features list.
1
When the device finishes scanning of the current original, load the next original.
2
Tap [Scan Next Original].
3
When all originals have been scanned, select [Scan Complete (Last Original)].
Confirming the Job Status
You can check the job status and cancel jobs.
1
Tap [Jobs].
The [Jobs] screen appears.
For information on jobs, refer to "Jobs" (P.219).
Interrupting the Copy Job
You can temporarily stop the copy job to have the device process another job.
The device may not accept job interruption if ten sets or less are being copied using the document glass.
1
Tap [Interrupt] at the bottom of the Home screen.
2
Load the original to be copied.
3
Configure the settings as required.
For information on the settings of each feature, refer to "Features List" (P.130).
4
Specify the number of copy sets with the numeric keypad.
5
Tap [Start].
6
When interrupt copying finishes, tap [Cancel Interrupt] at the bottom of the Home screen.
To Next Page
Loading...
Need help?
General
