5 Copy
138
the job after the confirmation. This feature also allows you to change the number of copy
sets. The sample copy is included in the total number of copy sets.
After a sample set is output, if the device is left uninstructed for the period specified in [Auto Clear], you can
set whether or not to start the data remained. For more information, refer to "[Paused Job Handling]" (P.265).
For more information on [Auto Clear], refer to "[Auto Job Release]" (P.249).
[Delete Outside / Delete Inside]
This feature allows you to specify the areas to be deleted from an original when making
copies. Specify two points on the document to set the area, and up to three areas can be
specified. You can also specify which side of the original to be deleted when the original
document is a 2-sided document.
[Next Original]
Use this feature when you copy an original that has too many pages to be loaded in the
document feeder at one time, or when you scan each page using the document glass and
make the device process the pages as one job.
When [Next Original] is set, a confirmation screen appears so that you can specify whether
the next original exists or not.
When using the document feeder, load the next original after the device has finished scanning the first
original.
To Next Page
Loading...
Need help?
General
