5 Copy
132
[Copy Output]
This feature allows you to set paper finishing options.
[Original Type]
Set an image quality type in accordance with the type of original documents.
[Mixed Size Originals]
Scans originals of the same width but different length at a time and copies them to each
size paper. Load the originals on the document feeder.
Align the both right and left edges of the originals to avoid a paper jam.
[Original Orientation]
This feature allows you to specify the orientation of an original so that the device can
identify the top of the original.
If the [Original Orientation] setting differs from the actual original orientation, the device may not detect the
top of the original correctly.
[Original Size]
The device detects the size of original automatically. You can specify a scan size for the
original when the original is a non-standard size or when you want to scan the original at a
size different from the size of original.
When the original is loaded in the document feeder, the base point in the Y (length) direction is the center of
the edge. If you specify 100 mm, the scan length will be from 50 mm above to 50 mm below the center of
the original.
If the size of original cannot be detected automatically, a screen to enter the size appears.
The sizes of original that can be automatically detected depend on [Paper Size Settings] in the System
Administration mode. For more information, refer to "[Paper Size Settings]" (P.263).
[Sharpness]
This feature allows you to adjust the sharpness of the image.
[Saturation]
This feature allows you to adjust the saturation of the image.
[Image Enhancement]
This feature allows you to suppress the background color of documents, such as newspaper
and colored paper. You can also adjust the contrast.
[Image Enhancement] is not available when [Original Type] is set to [Photo].
To Next Page
Loading...
Need help?
General
