Cleaning the Device
403
Cleaning Document Cover and Document Glass
If the document cover and document glass become soiled, smudges may appear on copies,
faxes, or scanned documents and the device may not properly detect document sizes.
To ensure clean copies at all times, clean the document cover and the document glass
about once a month.
Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint or coating on
plastic parts.
Cleaning the device with an excessive amount of water may cause the device to malfunction or damage
originals.
Do not use cleaning agents other than water or neutral detergent.
If you cannot remove dirt easily, gently wipe the document cover with a soft cloth moistened with a small
amount of neutral detergent.
1
Wipe the document cover with a water-moistened and firmly wrung soft cloth.
2
Wipe the document glass with a water-moistened and firmly wrung soft cloth.
3
Wipe off any excess water on the document cover and the document glass with a soft dry
cloth.
Cleaning White Chute and Constant Velocity Transport Glass
To ensure clean copies at all times, clean the Side 1 constant velocity transport glass and
the Side 2 constant velocity transport glass about once a month.
Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint or coating on
plastic parts.
Cleaning the device with an excessive amount of water may cause the device to malfunction or damage
documents during copying, faxing, or scanning.
Do not use cleaning agents other than water or neutral detergent.
If you cannot remove dirt easily, gently wipe the white chute with a soft cloth moistened with a small amount
of neutral detergent.
To Next Page
Loading...
Need help?
General
