Emulation
499
Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Active Coordinate
Area, Scaling: ON
Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Active Coordinate
Area, Scaling: OFF
Setting Menu Item Related to the HP-GL/2 Mode
[Port Settings]
Set the port used in emulation modes under [Device] >[Connectivity & Network Setup] >
[Port Settings].
Port Status (LPD/IPP/USB-/Port 9100)
Enables the ports to be used in the emulation mode.
[USB - Print Mode]
Sets the print mode of the USB port so that it can be used by HP-GL/2 emulation. Select
[HP-GL/2] as the print mode.
[USB - Print Mode] sets the method of processing data received from host interfaces. If this is set to [HP-GL/2]
here, the device will not switch languages automatically as described in "Switching between Printer
Languages" (P.479).
The print mode can also be specified for each protocol (LPD, IPP, Port 9100, or WSD) from CentreWare
Internet Services.
Active
Coordinate Area determined
by entered data
Paper Size
Print Area
Active Coordinate Area
determined by entered data
Paper Size
Print Area
To Next Page
Loading...
Need help?
General
