Scanner Environment Settings
59
For information on setting the TCP/IP address, refer to "Setting the IP address" (P.36).
Enabling Port
1
Log in to the System Administration mode.
For more information, refer to "Login to Authentication Mode" (P.77).
2
Tap [Device] on the Home screen.
3
Enable the port.
1) Tap [Connectivity & Network Setup] > [Port Settings] > [WSD] > [Port (Scan to Desktop)].
2) Tap [Enabled].
4
Press the Home button.
Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.