Using the Operator Panel Menus and Keypad
342
• TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
NOTE:
• To configure the IPv6 settings, use CentreWare Internet Services.
IP Mode Dual Stack*
Uses both IPv4 and IPv6 to set the IP address.
IPv4
Uses IPv4 to set the IP address.
IPv4 Get IP
Address
DHCP/Auto IP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator
panel.
IP Address
Manually sets the IP address allocated to the
printer.
Subnet Mask
Manually sets the subnet mask.
Gateway Address
Manually sets the gateway address.
To Next Page
Loading...
Need help?
General
