Fuji Xerox DocuPrint P355 d

202 Troubleshooting
Regi Jam (Exit Sensor On JAM)
Exit Jam (Exit Sensor Off JAM)
Problem Action
Regi jam (Exit Sensor On JAM)
occurs.
Ensure that the drum cartridge is installed correctly.
If the problem persists, replace the drum cartridge if you have a spare cartridge as
instructed in "Replacing the Drum Cartridge" on page 237.
Replace the drum cartridge if you have a spare cartridge.
See also:
• "Replacing the Drum Cartridge" on page 237
If the problem persists, ensure that the fusing unit is installed correctly.
Ensure that the fusing unit is installed correctly.
If the problem persists, replace the fusing unit as instructed in "Replacing the Fusing
Unit, Transfer Unit and Retard Roll" on page 240.
Replace the fusing unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit and Retard Roll" on page 240
If the problem persists, ensure that the transfer unit is installed correctly.
Ensure that the transfer unit is installed correctly.
If the problem persists, replace the transfer unit and the retard roll as instructed in
"Replacing the Fusing Unit, Transfer Unit and Retard Roll" on page 240.
Replace the transfer unit and the retard roll.
See also:
• "Replacing the Fusing Unit, Transfer Unit and Retard Roll" on page 240
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.
Problem Action
Exit jam (Exit Sensor Off JAM)
occurs.
Ensure that the fusing unit is installed correctly.
If the problem persists, replace the fusing unit as instructed in "Replacing the Fusing
Unit, Transfer Unit and Retard Roll" on page 240.
Replace the fusing unit.
See also:
• "Replacing the Fusing Unit, Transfer Unit and Retard Roll" on page 240
If the problem persists, contact the Fuji Xerox local representative office or an
authorised dealer.