Setting Up the Printer (Printer Setup)
20
Setting Up the Printer (Printer Setup)
2
Determining the Wireless Network Settings
You need to know the settings for the wireless network to set up the wireless printer. For
details of the settings, contact your network administrator.
* : Available only when [Infrastructure] is selected as Network Type.
Configuring the Optional Wireless LAN Kit
You can select a method to configure the Wireless LAN Kit from the following:
WPS-PBC
*1*3
WPS-PIN
*2*3
Auto SSID Setup
Manual SSID Setup
CentreWare Internet Services
*1 : WPS-PBC (Wi-Fi Protected Setup-Push Button Configuration) is a method to authenticate and register devices required for
wireless configuration, by pressing the button provided on your access point or wireless router. This setting is available only
when the access point supports WPS. Before starting WPS-PBC, check where the WPS button (button name may vary) on the
wireless LAN access point.
*2 : WPS-PIN (Wi-Fi Protected Setup-Personal Identification Number) is a method to authenticate and register devices required
for wireless configuration, by entering PIN assignments into the wireless LAN access point. This setting, performed through
access point, is available only when the access points of your wireless router supports WPS.
*3 : For WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless LAN access point.
[Wireless
Settings]
SSID A name with up to 32 alphanumeric characters, which identifies the
wireless network
Network
Type
[Infrastructure] or [Ad hoc]
[Security
Settings]
Encryption No security For the wireless setting without
specifying any encryption
WEP Requires a WEP key.
For a 64-bit WEP: up to 10-
hexadecimal character key
For a 128-bit WEP: up to 26-
hexadecimal character key
Transmit Key WEP key 1-4
WPA2 Personal
*
With AES method
Mixed Mode Personal
*
Automatically selects the
encryption type from WPA Personal
(AES), WAP2 Personal (AES) or WPA
Personal (TKIP).
Passphrase Alphanumeric characters from 8 to
63 bytes long and hexadecimal
characters of 64 bytes long
WPA2 Enterprise
*
With AES method
Mixed Mode Enterprise
*
Automatically selects an available
encryption type from WPA
Enterprise (AES), WAP2 Enterprise
(AES) or WPA Enterprise (TKIP).
Authentication PEAPv0 MS-CHAPv2, EAP-TLS, EAP-
TTLS/PAP, EAP-TTLS/CHAP or EAP-
TTLS/MS-CHAPv2